Moty's
English | China

MCS

Contact as

TEL :
+81-3-3806-8787

MOTY'S JAPAN Company Limited

2-25-4 Higashinippori Arakawa-ku, TOKYO
116-0014 JAPAN

TEL : +81-3-3806-8787
FAX : +81-3-3805-5362

TOP > Products > MCS

MCS inner engine cleaning system without dismantling

MCS

When carbon builds up inside the combustion chamber, ideal fuel/air mixture flow is disturbed and ideal combustion is impaired leading to power loss. The carbon on piston rings disturb their smooth movement and loose its designed compression. To remove these harmful carbon residues, Moty's MCS is developed.

Effect :

  • Removal of carbon residue in combustion chamber and on piston rings.
  • Increment of combustion efficiency reduction of harmful exhaust gas.
  • Increment of torque at mid/low speed range.
  • Significant reduction in maintenance cost.

Safety :

  • MCSNo chemical ingredients which are registered on PRTR(Pollutant Release and Transfer Resister) is used.(Except some items)
  • Unlike several ordinary carbon removers, this product considerably reduces strong oder, soring eyes and throat etc.
  • When you want to remove the carbon by dipping the parts, you can finish it much faster with this system than with ordinary system.
  • As regards chemical reaction on metals, this system is much safer than ordinary system.
    However, due to basic characteristics of this system, it may slightly corrode some metals. So, we recommend you dip the parts for no longer 24 hours. Regarding on rubbers and plastics, there is possibility to attack and react on these materials. Please be careful not to contact with rubbers and plastics.

Usage :

  1. When infusing from intake
    Use 300ml for 10 ~ 30 minutes M655 / MCS711(10 fold dilution by gasoline)
  2. When you cut off fuel line and connect to equipment which can put 1~2kg of fuel pressure and start the engine.
    Use 200 ~ 600ml for 15 ~ 30 min. while idling or idling up M655(10 fold gasoline dilution)/MCS711(5 fold gasoline dilution)
  3. When you put through each plug hole using syringe.
    Inject 40ml per each hole and leave it for 30 min. You can Should be within 24 hours. Normally few hours is enough to clean the parts. MCS721 / MCS711
  4. When you dip the parts
    Inject 40ml per each hole and leave it for 30 min. You can Should be within 24 hours. Normally few hours is enough to clean the parts. MCS721 / MCS711
  5. When you put in fuel tank
    M655/M651
TOP | Products | Moty's From Development Sites | Contact Us